Mix
Hose size recommendations (1”, 1 1/2”, etc…)?
Here is the link to the main plumbing article: Mixmate Plumbing Product Lines (Green lines in each diagram) A 1.25 inch (32 mm) hose is recommended for product lines between totes and input valves. This size allows good flowrates while also keeping ...
Why did my jug rinse activate on its own?
Typically this is an indicator of a failing sensor. The jug rinse sensor inside the inductor is commonly subjected to many different products and while we use high quality components, sometimes these products can get past seals and affect the sensor ...
Why did my product stop short/long of the target?
Mixmate uses a custom Machine Learning system to analyze how well it hits the desired target and will adjust how it operates the valves to hit those targets. If variables such as the pump is operating a different speed, this will affect how the ...
How do I get started? (Basic steps for starting your first mix)
Under Construction
I keep seeing a 203 error code when using the Inductor. What can I do about this?
Error 203 is thrown because the weight of the inductor is not becoming steady. This is likely due to a high vibration environment. The easiest way to tell how much vibration you have is to look at the tablet screen while it is in the tablet holder. ...
If a handpour is first in the Product List, will the other products hold back until the handpour is complete?
By default, Mixmate runs as many products as it can at the same time to complete the desired Mix efficiently. The goal here is to be injecting the products into the main stream of carrier on the way to the destination tank.
Why do dry products appear less stable on the scale readout than liquid products?
Below are the measurement increments of Mixmate inductors along with some conversions to help alleviate perceived differences when measuring different types of products. The Fusion Inductor resolution is 0.125 pounds. The Pro Inductor resolution is ...
Why am I getting a No Flow Error?
When the system is expecting to meter flow and is unable to do so, it is typically due to either a blockage, pump not running high enough, or simply a closed valve; the closed valves could potentially be manual ones inadvertently left closed, or it ...
Why does my tote have more/less in it than I expected?
The most common reason for this is an air leak in the plumbing. An air leak in plumbing joints does not always leak chemical onto the ground and as such will bring air in when under suction of the system running. If the gear meter(s) has been taken ...
My 2.5 gallon jug doesn’t measure 2.5 gallons, how do I fix this?
You bought the product as 2.5 gallon jugs, you want the Mixmate to match. There are 2 different ways to solve this discrepancy. 1. Check the scale calibration of the inductor found HERE 2. MOST COMMON SOLUTION: Adjust the density of the product by ...
Why is my inductor not draining?
There are multiple items to check here: 1. Are you getting weight readings in Manual Mode? How to get to Manual Mode 2. Has the drain weight been properly set? Here's How 3. Does the drain valve move in manual mode? How to get to Manual Mode 4. Are ...
Why is my continuous flow button not active?
The continuous flow button will be active when there is a container size set on the product. Here is how to set the container size: Data -> Products -> Select the product to change -> Enter the container size value and unit of measure -> Save
How do we achieve essentially a 50% water in the tank by starting many items at the same time?
Mixmate operates differently than the way it used to be done. First lets recap what the traditional way of mixing looks like before we dive into how the Mixmate essentially achieves this same process. The traditional way states that you need to fill ...