Hose size recommendations (1”, 1 1/2”, etc…)?
Product Lines (Green lines in each diagram)
A 1.25 inch (32 mm) hose is recommended for product lines between totes and input valves. This size allows good flowrates while also keeping the amount of product held in the hose at a low volume.
Rinse Lines (Red lines in each diagram)
As shown in figures above, the rinse line tees off between the main carrier meter and the carrier valve. The pressurized side of the rinse pump goes directly into the Mixmate inductor. The non-pressurized side supplies the stack manifold. Typically these lines are 1.25 inch (32 mm) as well.